This patch adds netdev ipvtap that is based on the
IP-VLAN network interface, called ipvtap. An ipvtap device can be created
in the same way as an ipvlan device, using 'kind ipvtap', and then accessed
using the tap user space interface.
Media Access Control Security (MACsec) is an 802.1AE IEEE
industry-standard security technology that provides secure
communication for all traffic on Ethernet links.
MACsec provides point-to-point security on Ethernet links between
directly connected nodes and is capable of identifying and preventing
most security threats, including denial of service, intrusion,
man-in-the-middle, masquerading, passive wiretapping, and playback attacks.
Closes#5754
When enabled, three samples are used to determine the value of a
received bit by majority rule.
This patch adds support for the TripleSampling= option in the [CAN]
section of .network files.
And before resolving NetDev names, check conditions in .network,
and if they do not match the system environment, drop the network
unit earlier.
Fixes#4211.
When there is bad link in the network the carrier goes up/down.
This makes networkd stops all the clients and drop config.
But if the remote router/dhcpserver running a prevention
of DHCP Starvation attack or DHCP Flood attack it does not allow
networkd to take a DHCP lease resulting failure in configuration.
This patch allows to keep the client running and keep the conf
also for this scenario.
Closes#9111
An earlier commit 0e408b82b (dhcp6-client: handle IAID with value zero)
introduced a flag to sd_dhcp6_client to distinguish between an unset
IAID and a value set to zero.
However, that was not sufficient and broke leaving the setting
uninitialized in networkd configuration. The configuration parsing
also must distinguish between the default, unset value and an
explict zero configuration.
Fixes: 0e408b82b8
When using networkd we currently have no way of ensuring that static
neighbor entries are set when our link comes up. This change adds a new
section to the network definition that allows multiple static neighbors
to be set on a link.
RFC 7084, WPD-4, requires Customer Edge end routers to behave
according to the following:
"WPD-4: By default, the IPv6 CE router MUST initiate DHCPv6 prefix
delegation when either the M or O flags are set to 1 in a
received Router Advertisement (RA) message. Behavior of the
CE router to use DHCPv6 prefix delegation when the CE router
has not received any RA or received an RA with the M and the
O bits set to zero is out of scope for this document."
Since it cannot be automatically detected whether DHCPv6 is to be
operated as an CE end router or whether to initiate an Informational
exchange to obtain other useful network information via DHCPv6 when the
Router Advertisement 'O' bit is set, a 'ForceDHCPv6PDOtherInformation'
boolean network configuration option in the '[DHCP]' section of a is
introduced. Setting this option causes DHCPv6 to be started in stateful
mode, although only the 'O' bit is seen in the Router Advertisement.
When 'ForceDHCPv6PDOtherInformation' is set and the Router Advertisement
has only the Other information 'O' bit set, disable requests for IA_NA
addresses.
Fixes#9745.
