They are not really boolean, because we have both ipv4 and ipv6, but
for each protocol we have either unset, no, and yes.
From https://github.com/systemd/systemd/issues/13316#issuecomment-582906817:
LinkLocalAddressing must be a boolean option, at least for ipv4:
- LinkLocalAddressing=no => no LL at all.
- LinkLocalAddressing=yes + Static Address => invalid configuration, warn and
interpret as LinkLocalAddressing=no, no LL at all.
(we check that during parsing and reject)
- LinkLocalAddressing=yes + DHCP => LL process should be subordinated to the
DHCP one, an LL address must be acquired at start or after a short N
unsuccessful DHCP attemps, and must not stop DHCP to keeping trying. When a
DHCP address is acquired, drop the LL address. If the DHCP address is lost,
re-adquire a new LL address.
(next patch will move in this direction)
- LinkLocalAddressing=fallback has no reason to exist, because LL address must
always be allocated as a fallback option when using DHCP. Having both DHCP
and LL address at the same time is an RFC violation, so
LinkLocalAdressing=yes correctly implemented is already the "fallback"
behavior. The fallback option must be deprecated and if present in older
configs must be interpreted as LinkLocalAddressing=yes.
(removed)
- And for IPv6, the LinkLocalAddress option has any sense at all? IPv6-LL
address aren't required to be always set for every IPv6 enabled interface (in
this case, coexisting with static or dynamic address if any)? Shouldn't be
always =yes?
(good question)
This effectively reverts 29e81083bd. There is no
special "fallback" mode now, so the check doesn't make sense anymore.
The link state file is always removed when networkd is stopping. So,
the deserialization logic does not work. Moreover, the ADDRESSES=
entry is not used by sd-network, so serialization is also not necessary.
Before this commit, event when Gateway=_dhcp4 or _ra is set, the
route was configured with 'protocol static', and other properties
specified by RouteTable=, RouteMTU=, or etc, were ignored.
This commit makes set the route protocol based on the protocol the
gateway address is obtained, and apply other settings if it is not
explicitly specified in the [Route] section.
With the changes from 2c0dffe82d, starting
systemd-networkd.service will also activate systemd-networkd.socket.
When tearing down a test, we need to stop the socket as well, to make
sure networkd can't be activated accidentally with the wrong
configuration.
For some reason the wait-online is failing intermittently; it's unclear
exactly why, but this hopefully avoids the failure for unrelated PR.
This is a workaround (not fix) for #16105
This test is failing becuase the setup state isn't reaching 'configured'
for unknown reasons; ignore the setup state for now to prevent failures
of CI until the reason can be investigated.
After today's Arch Linux image update, there seems to be a slight change
in delay reporting which breaks some asserts in
systemd-networkd-tests.py:
Expected:
limit 100 delay 50.0ms 10.0ms loss 20%
Current:
limit 100 delay 50ms 10ms loss 20%
The test currently doesn't actually test configure-without-carrier since
it does have carrier for the entire test. It now forces carrier down
before starting the network portion of the test. Also, it tests to verify
the configuration is retained across future carrier losses/gains.