Previously, on DHCPv4 address renewal, the old address may be removed
while the new address is not ready yet.
This also simplifies the logic of removing address and routes.
If DHCP4 client lost a lease, and then soon acquire new lease, then
the removal of the old address may not be completed. If that happens,
and the new and old addresses are the same, then the new address will be
considered as a foreign address. Such a situation can occur when the
DHCP4 server is restarted.
This makes networkd wait for the removal of the old address when a new
lease is acquired.
This also makes the link in configuring state when renewing address.
SR-IOV provides the ability to partition a single physical PCI
resource into virtual PCI functions which can then be injected in
to a VM. In the case of network VFs, SR-IOV improves north-south n
etwork performance (that is, traffic with endpoints outside the
host machine) by allowing traffic to bypass the host machine’s network stack.
This is an attempt to clean up the POP3/SMTP/LPR/… DHCP lease server
data logic in networkd. This reduces code duplication and fixes a number
of bugs.
This removes any support for collecting POP3/SMPT/LPR servers acquired
via local DHCP client releases since noone uses that, and given how old
these protocols are I doubt this will change. It keeps support for
configuring them for the dhcp server however.
The differences between the DNS/NTP/SIP/POP3/SMTP/LPR configuration
logics are minimized.
This removes the relevant symbols from sd-network.h (which is an
internal API only at this point after all).
This is unfortunately not well test, given the old code for this had
barely any tests. But the new code should not perform worse at least,
and allow us to release, since it corrects some interfaces visible in
the .network configuration format.
Fixes: #15943
To make Driver= in [Match] section work in containers.
Note that ID_NET_DRIVER= property in udev database is set with the
result of the ethtool. So, this should not change anything for
non-container cases.
Closes#15678.
In DHCPv6-PD environment, where WAN interface requests IPv6 via DHCPv6,
receives the address as well as delegated prefixes, with LAN interfaces
serving those delegated prefixes in their router advertisement messages.
The LAN interfaces on the router themselves do not have
the IPv6 addresses assigned by networkd from the prefix it
serves on that interface. Now this patch enables it.
Defines how link-local and autoconf addresses are generated.
0: generate address based on EUI64 (default)
1: do no generate a link-local address, use EUI64 for addresses generated
from autoconf
2: generate stable privacy addresses, using the secret from
stable_secret (RFC7217)
3: generate stable privacy addresses, using a random secret if unset
Similar to the link->setting_mtu flag, this delays continued configuration
until after the genmode has been successfully set; this is important
because we do not want networkd to raise the interface before the genmode
has been set, as if we're disabling the genmode, raising the interface
before we have successfully disabled the genmode will result in the kernel
creating a ipv6ll address, even though we don't want that.
The kernel resets the ipv6 mtu after NETDEV_UP or NETDEV_CHANGEMTU event,
so we must reset the ipv6 mtu to our configured value after we detect
IFF_UP flag set or after we set the device mtu.
Fixes: #13914.
When nspawn container with private network starts, networkd creates
the default route for the interface. The route may cause problem on
the host side, and it can be created with DefaultRouteOnDevice= now.
Hence, this makes networkd not create the route implicitly any more.
Closes#13418.
*We* control the sysctl setting. If the user configured IPv6, then we apply the
settings, and just make sure that at some point during the configuration the
sysctl is disabled (i.e. ipv6 enabled) if we have IPv6 configured.
Replaces #13283.
It seems that old kernels do not support prefix routes with
non-default route tables. This adds a fallback logic when adding route
fails. In that case, prefix route is created by kernel and the default
route table is used.
The flag IFA_F_NOPREFIXROUTE was introduced in kernel-3.14. But even if
the kernel does not support the flag, it should be just ignored. So, it
is not necessary to do the fallback logic. Moreover, the current logic
is not a fallback mechanism but just retrying. So, it should not work.
Let's drop that.
